
Begin by taking your red ribbon and wrapping it around the Large Styrofoam Wreath. Adhere each end of the ribbon to the back of the wreath with a dot of Hot Glue. This will give your wreath a more finished look once the balloons are attached!

Once the wreath is covered in ribbon, take 2 different colored Round Latex Balloons and over lap the necks of the balloons. Next, push a greenery pin upwards through the overlapped balloons.

Turn the pin over and push the pin into the wreath.

Continue this process until your wreath is fully covered in balloons except for a small section where you will attach the ribbon to hang your wreath! We used approximately 100-125 Round Latex Balloons. Make sure the balloons are overlapping one another on the wreath so barely any ribbon is showing.

Hot Glue the Brown Bear 3-D Centerpiece to the bottom section of the wreath.

Loop a piece of red ribbon at the top of your wreath for hanging.

Your wreath is now ready to hang! We felt like this DIY Balloon Wreath was the perfect way to welcome our little cubs to our party! Make sure to check out our Brown Bear Birthday Party, DIY Brown Bear Centerpiece and Bear Paw Print Cookie Recipe for even more Brown Bear Party inspiration!

Begin by taking your red ribbon and wrapping it around the Large Styrofoam Wreath. Adhere each end of the ribbon to the back of the wreath with a dot of Hot Glue. This will give your wreath a more finished look once the balloons are attached!

Once the wreath is covered in ribbon, take 2 different colored Round Latex Balloons and over lap the necks of the balloons. Next, push a greenery pin upwards through the overlapped balloons.

Turn the pin over and push the pin into the wreath.

Continue this process until your wreath is fully covered in balloons except for a small section where you will attach the ribbon to hang your wreath! We used approximately 100-125 Round Latex Balloons. Make sure the balloons are overlapping one another on the wreath so barely any ribbon is showing.

Hot Glue the Brown Bear 3-D Centerpiece to the bottom section of the wreath.

Loop a piece of red ribbon at the top of your wreath for hanging.

Your wreath is now ready to hang! We felt like this DIY Balloon Wreath was the perfect way to welcome our little cubs to our party! Make sure to check out our Brown Bear Birthday Party, DIY Brown Bear Centerpiece and Bear Paw Print Cookie Recipe for even more Brown Bear Party inspiration!